Thank you for answers.
Yes, I did all that you said:
- generated log during 1st pass in VD
- tested settings of the 2nd pass in VD
- saved processing settings (and tested their load too
)
But when tried them in the above mentioned script it seemed that the call of the filter makes no changes to the clip.
Finally I found a workaround - old good frameserving from VD
Thanks for pixel aspect ratio note, but I have no idea about the source of the .mpg file (it is an old russian cartoon about dreams of a bear -
ftp://mp3.int.ru/pub/mp3/DISK_5/tmp/medvezhut.mpg
- no language required
). And it seams that square pixels look good enougth.
BTW, could you give another piece of advice:
Can these settings be used for stabilazing small shakes of digitized film material?
They have no rotation and are usually less than 1% (1% and 1 degree are the minimal values of "Max. correction limit" fields of the 2nd pass - but they cannot be lowered, right?).