Any thoughts on my query about applying the temp gauss to progressive material?
Although applying Merge(SelectEven(), SelectOdd(), 0.5) to the output gives quite good results, I realize that the gauss itself has been applied over (near identical) dupe frames which will have disrupted the motion flow.
Tried tinkering myself, using merged dupes from the dbob and edi, or replacing dbob with the source clp itself, but I suspect this is screws up the temp gauss and mask tuning etc. I’m wondering if applying the gauss to the masked difference between the dupe frames and then adding this back to the merged dupes, might be a better approach, but am unsure how to set this up and what would be the better source for the dupes, a dbob or edi?
Do you think this would be a valid approach or am I completely off whack?
Cheers.