Quote:
Originally Posted by huhn
399.07 960
displaycal 3.7.1.4
windows 10 17134
no correction
simulation profile DCI P3 D65
send bt 2020 was not used
screen with native gamut
biggest delta E between 8 bit at 8 bit and 10 bit output at 12 bit 0.2.
the used vertification testchart only uses 50% steps(didn't know that before) i do a proper one on the weekend or maybe today.
BTW. i'm not even aware of a LCD screen that can do DCI p3 100 %.
|
Thanks a lot for checking this that quickly. Much appreciated.
I'll run some tests in displayCAL with your driver version to try to isolate where the issue might be coming from.
I never measure LCD monitors because I don't calibrate them. I only calibrate what I use to watch films, and that's never a monitor or even a TV.
I use a JVC RS2000 projector and with the P3 filter it can reach 100% of P3 in high lamp. Some units (not mine) can reach up to 108% of P3 with the filter. The Z1/RS4500 (laser) can reach even wider than that. On the new models such as my previous rs500, there are two filters, one green and one red (well, a dichroic filter if you prefer). On earlier models (that were also able to reach 100% of P3), there was only one green filter. Without the filters, they reach around 85-95% of P3, depending on the unit.