Quote:
Originally Posted by hifreak
Hi I could use a little help. I installed the new version of BD Rebuilder and the recommend programs. When I run it the fist time it ask me to setup which is fine, but when I afterwards run the inspect file I get this:
Windows Version: 6.1 [7601]
- AVISYNTH Version: [2.5.8.0], Ok
- HAALI Splitter: [1.9.42.1], Ok
- FFDSHOW: [4504], Ok
- WIN7 preferred AVC CODEC: Not Set correctly
- WIN7 preferred VC-1 CODEC: Not Set correctly
- WIN7 preferred MPEG2 CODEC: Ok
- FFDSHOW VC-1 set to "wmv9", Ok
- FFDSHOW MPEG2 set to "libavcodec": Ok
- FFDSHOW AVC set to "libavcodec": Ok
- BD Rebuilder v0.44.0.16, Ok
- X264: Ok
- AFTEN: Ok
- FAAC: Ok
- WAVI: Ok
- TSMUXER: Ok
What have I been doing wrong cause I donīt understand why there is a mistake when BD Rebuilder did the job? I am on Windows 7
|
From the first page of this thread and the installation instructions:
Quote:
|
Note to Windows 7 & Windows 8 Users: The first time (and only the first time) you run BD Rebuilder, you may have to "Run As Administrator". This is necessary so BD-RB can make CODEC preference changes in the Windows Registry.
|
Your preferred codecs aren't being set -- or some other program is resetting them.
It's possible that you may have installed CODEC packs or software that changes your settings without your permission -- if so you need to dump them.