Over the last week the
Output Speed option has started giving problems. If I use any setting other than
default then
- The FPS on the main screen does not change
- The Duration on the main screen does not change
- Once encoding is started a 'info.txt does not exist' error is generated
After which the script goes directly to the final re-encode and shows 'Error: The file 'H:\Temp\RipBot264temp\job2\video.265' could not be opened for reading: open file error.'
Re-setting
Output Speed to
default allow the program to run.
I use this option where I have used MkvCutter to edit and re-encode the start of a video. As it re-encodes at 24 fps regardless of the speed of original, I need to use the
Output Speed to prevent the audio and video being out of sync.
I have tested on the same video, before and after using MkvCutter, in each case RipBot264 runs normally if Output Speed is default and fails for any other setting.